potentiometer standard .375 bushing 3/8 diam. 500K linearValue:Typically 250K pots are used for single coil pickups and 500K pots for humbucker pickups. The bigger the resistance value the brighter the sound will be/ less highs will bleed off. 1MEG can be used to make humbuckers sound brighter.Taper:The taper of a pot refers to the way its resistance changes as the shaft is rotated. A linear taper pot will work in a linear way related to shaft rotation. As the human ear is not linear in response to increasing volume an audio (aka. logarithmic) pot will work best for volume applications.A third option available is ‘vintage audio taper’. These pots are 30% logarithmic: with the pot halfway open the audio response/output is at 30%. Audio/log pots have an output of 10% in the same setting linear pots are at 50% output. So their taper is roughly halfway in between audio/log and linear taper pots. They are very similar to the original spec for vintage Stratocaster® guitar pots and can be used for both tone and volume controls.Shaft:A split knurled shaft will hold most knobs. Sometimes the knob is mounted using a set screw. You should order a solid shaft pot or align the set screw with the split for correct mounting.Bushing:The standard bushing diameter is 3/8 or 9 5mm used in most made in USA guitars. Another industry standard is M8 as used by guitar builders outside of the USA. When space is limited mini pots are used with a shaft diameter of 7mm.The standard bushing length is .375 for inch type pots and 10mm for metric type pots. Using two nuts it is very easy to set the correct bushing length for knob placement. Specially for pickguard (ST PB) or control plate mount (TE JB) the .250 short bushing will fit perfectly using only one nut.For use with a thick or carved top (LP USA) you should order a bushing length of .750 .CTS is (and has been since the 50''s) a factory standard for most USA brands like Fender